writeconf file Writes the configuration into a file. If file is omitted, the default file /etc/isdn/isdn.conf will be used. readconf file Reads the configuration from a file. If file is omitted, the default file /etc/isdn/isdn.conf will be used.
Syntax of the configuration fileThis syntax will be used for the options readconf and writeconf. All entries are included in the section [ISDNCTRL]. This section contains an entry INTERFACES, which describes the interfaces. Each subsection [INTERFACE] or [SLAVE] describes one interface. There are the following entries possible: NAME = name The name of the interface. This entry is required. Example: NAME = ippp0 EAZ = eaz Set the EAZ or the MSN. This entry is required. Example: EAZ = 4711 PHONE_IN = num [num...] Set the incoming phone number(s). It requires at least one blank between the different numbers. Example: PHONE_IN = 08151234 08151235 08151236 PHONE_OUT = num [num...] Set the outgoing phone number(s). It requires at least one blank between the different numbers. Example: PHONE_OUT = 08151237 08151238 SECURE = on|off Turn on or off the security feature. Example: SECURE = on CALLBACK = off|in|out Selects callback mode. Example: CALLBACK = in CBHUP = on|off Turns on or off hangup before starting callback. Example: CBHUP = on CBDELAY = seconds Set the callback delay to seconds. Example: CBDELAY = 5 DIALMAX = num Set the number of dial atempts to num. Example: DIALMAX = 1 HUPTIMEOUT = seconds Set the hanguptime to seconds. Example: HUPTIMEOUT = 20 IHUP = on|off Turns on or off the hangup timeout for incoming calls. Example: IHUP = on CHARGEHUP = on|off Turns on or off hangup before next charge info. Example: CHARGEHUP = on CHARGEINT = seconds Sets the charge interval to seconds. Example: CHARGEINT = 1 L2_PROT = protocol Set the layer-2 protocol. Allowed values for protocol are x75i, x75ui, x75bui and hdlc. Example: L2_PROT = hdlc L3_PROT = protocol Set the layer-3 protocol. Allowed value for protocol is only trans. Example: L3_PROT = trans ENCAP = encapsulation Sets the encapsulation mode. Allowed values for encapsulation are rawip, ip, cisco_h, cisco_hk, ethernet, syncppp and uihdlc. Example: ENCAP = rawip ADDSLAVE = slave Adds a slave interface for channel-bundling. Example: ADDSLAVE = s-ippp0 SDELAY = seconds Set the delay in seconds for the slave-dialing. Example: SDELAY = 10 TRIGGER = cps Set trigger level for slave-dialing. Example: TRIGGER = 4000 BIND = driverId,channel Binds the current interface to a specific physical channel. Before and after the comma may not be a blank. Example: BIND = teles1,0 PPPBIND = num Binds the current interface to the ippp device /dev/ipppX. This works only for syncronous ppp. The value must be a number. Example: PPPBIND = 0 Example for a configuration file [ISDNCTRL]
INTERFACES = {
[INTERFACE]
NAME = isdn0
EAZ = 4711
PHONE_IN = 08151234
PHONE_OUT = 08151234
SECURE = on
DIALMAX = 1
HUPTIMEOUT= 20
IHUP = on
CHARGEHUP = on
L2_PROT = hdlc
L3_PROT = trans
ENCAP = rawip
ADDSLAVE = s-isdn0
SDELAY = 10
[SLAVE]
NAME = s-isdn0
EAZ = 4711
PHONE_OUT = 08151234
SECURE = on
DIALMAX = 1
HUPTIMEOUT= 10
IHUP = on
CHARGEHUP = on
L2_PROT = hdlc
L3_PROT = trans
ENCAP = rawip
[INTERFACE]
NAME = ippp0
EAZ = 4712
PHONE_OUT = 08151235 08151236
SECURE = on
DIALMAX = 5
HUPTIMEOUT= 200
IHUP = on
CHARGEHUP = on
L2_PROT = hdlc
L3_PROT = trans
ENCAP = syncppp
PPPBIND = 0
} 0
Johanes Gumabo
Data Size : 13,592 byte
man-isdnctrl_conf.8Build : 2024-12-05, 20:55 :
Visitor Screen : x
Visitor Counter ( page / site ) : 3 / 185,782
Visitor ID : :
Visitor IP : 13.59.116.142 :
Visitor Provider : AMAZON-02 :
Provider Position ( lat x lon ) : 39.962500 x -83.006100 : x
Provider Accuracy Radius ( km ) : 1000 :
Provider City : Columbus :
Provider Province : Ohio , : ,
Provider Country : United States :
Provider Continent : North America :
Visitor Recorder : Version :
Visitor Recorder : Library :
Online Linux Manual Page : Version : Online Linux Manual Page - Fedora.40 - march=x86-64 - mtune=generic - 24.12.05
Online Linux Manual Page : Library : lib_c - 24.10.03 - march=x86-64 - mtune=generic - Fedora.40
Online Linux Manual Page : Library : lib_m - 24.10.03 - march=x86-64 - mtune=generic - Fedora.40
Data Base : Version : Online Linux Manual Page Database - 24.04.13 - march=x86-64 - mtune=generic - fedora-38
Data Base : Library : lib_c - 23.02.07 - march=x86-64 - mtune=generic - fedora.36
Very long time ago, I have the best tutor, Wenzel Svojanovsky . If someone knows the email address of Wenzel Svojanovsky , please send an email to johanes_gumabo@yahoo.co.id .
If error, please print screen and send to johanes_gumabo@yahoo.co.id
Under development. Support me via PayPal.